PL rapping style single dust collector PL single dust collector is a small, smart appearance, high removal efficiency of in situ dust emissions unit. Dust the components are mounted in a vertical frame, steel housing, rust overall after baking, beautiful appearance, reasonable structure, safe, reliable, easy to use. Mainly for small-density non-fibrous dust removal applications, and dust removal efficiency up to 99.9%. Equipment Technical Specifications: Model PL-800 / A PL-1100 / A PL-1600 / A PL-2200 / A PL-2700 / A PL-3200 / A PL-4500 / A PL-6000 / A PL-10000 / A wind mh 800 1100 1600 2200 2700 3200 4500 6000 10000 funding pressure Pa ~ 800 ~ 800 ~ 800 ~ 800 ~ 800 ~ 800 ~ 800 ~ 800 ~ 800 Filter area m 3 4 6 8 10 12 15 20 40 fan motor power Kw 0.75 1.1 1.5 2.2 34 5.5 7.5 15 cleaning Motor power Kw 0.18 0.18 0.18 0.18 0.18 0.18 0.25 0.25 0.25 filtration velocity m / min 3.33 2.62 2.6 3.05 3.3 3.48 3.49 3.33 3.33% removal efficiency of> 99.5> 99.5> 99.5> 99.5> 99.5 > 99.5> 99.5> 99.5> 99.5 gray tank capacity (L) 15 20 30 40 40 50 55 70 100 1 ﹑ structure building ventilation fan with centrifugal fan structure, air volume, high pressure, and use muffler measures, the use of noise small. 2 ﹑ dust bag of 208 industrial polyester needle felt filter selection, bag structure as flat bags, each bag are equipped with spring skeleton, filter effects, easy to change filter bag, long service life. 3 ﹑ precipitator cleaning mechanism using a motor with an eccentric, driven by the connecting rod of the bag and shake to clear dip in the dust dust bag outer surface. Control cleaning bodies in the two manual and automatic control; self-control that is the fan continuously, rapping cleaning may be required to conduct its own; that is, after the fan stops manual, automatic cleaning mechanism work, automatically stop after several seconds. 4 ﹑ installed on the filter housing has spacious and sealing access doors, easy to replace and repair the internal components of the bag. 5 ﹑ dust components drawer type structure, with easy operation and cleaning. 6 ﹑ dust on one side of the dusty gas inlet can be connected with unpacking mouth, feeding gray, sand box, vibrating screen, crusher, bucket elevator and belt conveyor dust equipment. The working principle and control (1) How it works: dusty gas by the fan (installed in the box top) is drawn into the chamber (from the middle or lower case entering) after the bag filter, dust is retained on the surface of the filter bag, purified gas sucked into the fan from the exhaust outlet. When the dust bag surface increases with the accumulation of thick dust, increase the resistance of the bag to reduce the collection efficiency, in order to ensure efficient use of filter must remove accumulated dust bag surface, within PL single dust collector unit is equipped with controlled cleaning rapping timing device to clean the surface of the dust bag. (2) operational control: the dust blower motor 1D, cleaning motor 2D (J-type with cinder motor 3D), are access to electronic control box, then put through a three-phase four-wire 380V AC power supply, the control loop is 220V and access to a reliable ground.